NIPPY NP-S7B Ski-mini, Instruction Manual

Page: 4 / 16

2
■Handling Instructions■
⚫
Do not burden the machine.
（
extremely thick or hard
）
⚫
Do not use where it gets wet. Avoid using wet hands.
⚫
Be careful not to touch the cutting edge when replacing blade.
⚫
Keep your fingers away from the blade while operating.
⚫
Not to give excessive shock such as falls.
⚫
Do not operate with the presser foot in contact with the roller or cutter.
⚫
Do not operate the roller in contact with the blade.(It may cause the blade to chip or the
sharpness to deteriorate quickly.)
⚫
Do not stop the processed product and keep moving the skiving Machine.
（
It will cause the
sharpness to deteriorate quickly
）
⚫
Never run continuously for more than 15 minutes. (interval 45 minutes)
⚫
Be sure to keep the cardboard boxes that the machine was in.
➢
（
It is used when shipping to our company if there is a problem.
）
■Safety device■
⚫
Spindle motor
・
Feed motor
✓
There is a safety device that automatically shuts off the machine when a certain load is
applied.
✓
Once the safety device has been activated, turn off the main power and remove the one
with tools that caused the overload.
✓
At this time, be careful not to touch the blade with your hands.
✓
If it can be confirmed that it has been removed, turn on the main power again and check that
the indicator lamp is light in green before restarting operation.
⚫
Main circuit
✓
If the circuit is shorted, the fuse built into the main unit will blow.
✓
If the fuse is broken, replace it with a new one. Refer to 8
page“ Fuse Replacement”.
■
Make sure to check the following items before work
■
⚫
Check if each part has no loose screws.
⚫
Check that the blade and presser foot are firmly fixed.
⚫
Check if the presser foot is not in contact with the blade or roller and the roller is not in contact
with the blade.
⚫
Adjustment the thickness in trial and then work on it.