D-F10120 NP-F369 Product Spec Rev.0.01(Provisional Ver.)
23
2)Memory Switch MS2
Default setting
Function O
N
OFF
NP-F369
MS2-1
Japanese Kanji code
Shift JIS
JIS
OFF
MS2-2
OFF
MS2-3
Built-in Language font Switch
See Table.3
OFF
MS2-4
Paper Near end
Ineffective
Effective
OFF
MS2-5 Reserved
Note
２
－
－
OFF
MS2-6 Mark
sensor
Center Side OFF
MS2-7
Receive buffer remaining
amount auto-reply (USB)
*NOTE3
Ineffective Effective
OFF
Function B
Function A
MS2-8 Select
Bezel
function
See Table.4
OFF
*
Note
２
Reserved MS2-5 must be “OFF”.
*
Note3
When setting MS2-7:ON, beware print failures such as garble characters may occur if
transmitting large amount of data at once. Valid only with USB interface.
Table 3: Installed Language Fonts
Installed
language fonts
MS2-2 MS2-3
Japanese
OFF OFF
Chinese
O N
OFF
Korean
OFF O
N
Greek
O N
O N
*Japanese JIS C 6226
＋
JISX0213:2004
＋
Personal name Kanji 2010
：
Full size
Domestic Character Code
＋
Overseas Character Code
＋
Code Page 858
＋
International character
：
Half size
*Korean KS X 1001:1992
：
Full size
Katakana character set
＋
Extended graphic character set
＋
Code Page 858
：
Half size
（
KS X 1001:1992 installed font
）
*Chinese GB18030-2000
：
Half/Full size
*Greek Code Page1253
：
Full size
（
character code is 1 byte code
）
*Refer to command [Character Code Table Selection]
《
ESC t n
》
for other language fonts.
Table 4
Bezel function
Common for Bezel
function A/B
When the distance to next cutting after previous cutting is less than
55mm, feeding paper will be operated till it becomes 55mm.
Bezel functionA
When the extract sensor on Bezel detects paper-in, status will be
Bit6”1”. When detects paper-out, status will be Bit6”0”.
Bezel function B
When the extract sensor on bezel detects paper-in after cutting, Status
will be Clamp state (Status Bit6 "1"). During clamp state, printing will not
be operated even if printing data is received. When paper-out is
detected, Status will be canceled (Status Bit6 "0").
The paper detection error(Status Bit5 "1") will be detected when the
extract sensor on bezel cannot detect paper-in even if the distance to
next cutting after previous cutting is more than 50mm.
*Bezel function is available with BEZ-320/330(with LED lighting function) or BEZ-221/231(with bezel
sensor).
