2.6
Power Supply Specifications
1) Power supply input connector
2 pin connector
Connector below will be connected to this connector. (Power supplied externally.)
Printer side connector: S2P-VH (LF) (SN) JST or equivalent.
Adapter side connector: VHR-2N JST or equivalent.
No function
1 +24V
2 GND
Connector Fig
（Look from a fit side）
1
2
2)Power Supply Voltage
：
DC24V±5%
3)Current Consumption
Under review
（TBD）
【
Notice
】
*NOTE1
: A power supply with enough capacity is required in order to secure a good printing quality.
Depending on the printing contents, the current may be big at the peak time.
*NOTE2
: If power supply cable is excessively long, the operation may become unstable. Cable should be
made as short as possible. If not available, connect cables near the printer and place an
electrolysis condenser of 2200
μ
between power supply and ground. Rating voltage should be
higher than 35V.
*NOTE3
:A LPS power supply is recommended.
D-F10120 NP-F369 Product Spec Rev.0.01(Provisional Ver.)
13
