Ningbo BPS 101, Operating Manual

Page: 30 / 92

and cut the extra master.
10mm to the cutter blade, pull the master straight, and
“Open” position, put the master head between the print
the print roller and thermal head, keep pressing the cutter
2. Press down the thermal head release lever to “Open”
position;
Notes
Do not touch the thermal head,
，
otherwise it shall be scraped, which
shall effect master making quality.
3. Put the new master roll onto the master bracket;
4. Three ways of installation:
Way
Ⅰ
Feed the master head (with mill finish adown)
between the printing roller and the thermal head, and push
the release lever to position “Close”. Close the scan table
and then master making can be started.
Way Put the thermal head release lever to
Ⅱ
“Close”
position, master mill finish adown, put the master under
micro switch, the master feed forward automatically, when
the distance is 5-10mm to the cutter, then use right hand to
press thermal head release lever, with left hand pull the
master to the feed entrance, close the scan table and then
master making can be started.
Way
Ⅲ
Put the thermal head release lever onto the
roller and the thermal head, feed the master forward until
release the thermal head release lever to “Close” position.
Press the cutter micro switch
Take out the cut master piece. Close the scan table and then
master making can be started.
28