Page 11
TURN ON THE MACHINE
Press the power button to turn on the machine. The machine will be in preheated
mode at the same time.
TURN OFF THE MACHINE
Press the power button again, the machine will be off.
PROGRAMMING THE WATER VOLUME
Insert a capsule, close the lever and press the button of the drink that you’d like
to re-program.
Keep this button pressed for at least 3 seconds, then release it.
The drink is being prepared, press the same button again once the desired drink
volume has been dispensed.
This volume is now stored as default drink value for that button.
RESET THE FACTORY DEFAULT
Press the espresso / lungo button over 3 seconds, the related button will blink 3
times, it means that the machine is running to the factory default.
STAND BY
Whenever the machine is inactive for more than
9
minutes, it enters
automatically in stand-by mode to save energy consumption, the lights will be
off.
Espresso capsule coffee maker
DESCALING
It is advisable to descale the machine yearly, depending on the frequency of
use and the mineral content of the water.
Descale using commercial descaling agent recommended for espresso coffee
makers, or use water with vinegar as follows:
•
Fill the water tank with recommended JDE premix part# 55119528 or 5%
vinegar solution.
•
Without inserting any capsules, press and hold the espresso/ lungo/hot water
extraction button for 3 seconds at the same time. The button’s light is blinking
and the liquid is extracting automatically.
This indicates the machine is in the descaling mode.(The extracting stops
automatically while the liquid is up to 160 ml +/-15%)
•
After that, rinse the water tank and let or 2 tanks of fresh water flow through
the brew head until there is no more smell of the descaling agent.
Note: This operation may be dangerous if other substance are used instead of
JDE approved de-scaling materials recommended for household coffee makers.
CLEANING
•
Use a damp cloth to clean the body of the machine and do not use abrasive
detergents
•
Remove the used capsule container, the cup tray and the drip tray
(Fig. 1 - 9 to 11).
•
Empty any capsules and wash them with a mild non-abrasive cleaning agent.
•
Periodically remove the water tank (Fig. 1 - 3) and rinse it with clean water
then put it back properly in its place.