IMPORTANT:
Place the motor base on a clean, dry, level surface such as a
counter or table top.
1. Make sure that the motor base is plugged in for use.
No lights will turn on.
2. Add ingredients to the jar.
NOTE:
Do not overfill! To avoid spilling, do not add ingredients past the “Max”
fill line.
3. Place the blade onto the jar and twist it on tightly until you have a good
seal.(Fig. 1)
4. Turn the jar upside down and place it onto the motor base, aligning the tabs
on the jar with the motor base, aligning the tabs on the jar with the motor
base. Turn it clockwise, until you feel it click into place. The unit is ready for
use.(Fig. 2)
5. Press one of the buttons to activate. (Fig.3)
NOTE:
When using the Nutri-iQ presets, the unit will operate using pulses,
pauses and continuous runs. The pauses allow the contents of the cup to
settle. When the timer reaches “0”, it will stop by itself.
6. To remove the jar, ensure that the motor has stopped running. Then turn
the jar counter clockwise. .(Fig. 4) and pull straight up to remove(Fig. 5)
7. Turn the jar upright and remove the Blade Assembly by twisting the blade
assembly counter clockwise. Be sure to store the Blade Assembly attached
to an empty jar when not in use.
8. Twist the Sip & Seal lid onto the jar to enjoy your drink on the go. Press flip
top cap firmly into the opening to get the best seal. The flip top cap locks
open when pressed backward.
9. Make sure that the motor base is unplugged when not in use.
10.To remove the motor base unit, tip the unit forward from the rear to easily
disengage the suction cups.
