12
Roll:
If you move the roll
stick to left or right,
the helicopter flies
in the corresponding
direction.
Climb / descent:
When you move the
throttle stick up or
down, the helicopter
climbs or descends.
Yaw:
If you move the tail
rotor stick to left or
right, the helicopter
rotates in the corre-
sponding direction.
Pitch-axis:
If you move the
pitch-axis stick up or
down, the helicopter
will fly forward or
back.
Controlling the model
These points must be checked before flying:
- Before flying the model check that the receiver battery is
fully charged, and that the transmitter batteries still have
adequate capacity.
- Ensure that the throttle stick is at the lowest position (fully
back) before switching the model on, and that all other
sticks and switches are in the normal position.
- Check that all servos are working perfectly.
- Check that each component has been installed correctly.
- Check that the whole model is in perfect technical condi-
tion.
- When it is time to switch the receiver and transmitter on
or off, please observe the following procedure:
- Always switch the transmitter on first, and only then
the receiver.
- After the flight always switch the receiver off first,
and only then the transmitter.
If you fail to keep to this
sequence, the model could fly off out of control.
- Check that all linkages are correctly fitted and devoid of
lost motion; replace them if necessary. Sloppy linkages
may cause instability in flight.
- Before flying the model, check that the connection bet-
ween flight battery and model is secure. Vibration during
a flight may cause the connectors to work loose; the mo-
del would then be out of control.
Mode 1 Mode 2
