Nine Eagles Galaxy Visitor 7, Instruction Manual

Page: 9 / 28

5
Ⅲ.
Operation Manual
【
Picture
3 】
【
Picture
5 】
【
Picture
4 】
【
Picture
6 】 【
Picture
7 】
1.Charging the Li-po battery
：
Warning ! The charger contains protective circuitry. If you experience any difficulties while
charging the battery, please disconnect the battery from the charger and unplug the charger
from the power source. Allow the battery and the charger to rest for two hours as this will allow
the charger protection circuit to rest. If this issue re-occurs during normal use, please contact
technical support for further assistance.
1) Plug the USB charger into your USB port.
2) Plug the Li-po battery into the USB charger. The power indicator light on the charger turns to
solid on. It means charging. Once charging is finished, the power indicator light will flash slowly.
Please pull them out.
Below table shows different status in charging:
Charger status
To be charged
Charging
Full charge
Charging error
Charger indicator status
off
Solid on
Slow flash
Quick flash
This USB charger can recognize different charger power supply sources. When using computer
as the power supply source, the charging current is about 500mA and the rough charging time will be
70 minutes. When using charge power bank as the power supply source, the charging current is
about 1000mA and the rough charging time will be 45 minutes.
2.Install the Transmitter Battery
1) Remove the battery cover. (pic.5)
2) Install 4pcs AAA batteries and check the polarity of each battery. Transmitter won't power
on if
battery wrongly installed. (pic. 6)
3) Slide the battery cover back into place (pic.7)
GALAXY VISITOR 7
NE-MASF25