3)
Land
:
Before landing, try to keep quadcopter hovering stably. Then click 15 Land switch. Quadcopter will
land slowly to the ground.
4) Emergency Land
:
In case of emergency, click 10 Emergency Landing. Motor will stop rotating at once and
quadcopter will fall down immediately.
This function is only for emergency use. Please think carefully before using it because it
may damage the quadcopter.
Attention:
9.Basic maneuvers
Tail towards pilot
:
Slowly Rotation
:
Firstly turn the quadcopter tail towards to you without deflection.
Then moving elevator stick forwards slowly and quadcopter will fly forwards at slow speed.
And moving elevator stick backwards slowly and quadcopter will fly backwards at slow speed.
Practicing again and again till you feel comfortable on it.
After that, moving the aileron stick left, the quadcopter will move left. And moving the aileron stick
right, the quadcopter will move right. Practicing again and again till you feel comfortable on it.
Add a small amount of rudder stick (left or right) and try rotating the quadcopter slightly sideways
and see if you can hold it there.
If you feel uncomfortable, then bring the tail back towards you. Practicing again and again until you
feel comfortable on rotation.
The quadcopter will probably drift during these practicing, so make sure you have plenty of room
After above practicing, if you feel comfortable, moving aileron stick left that will cause quadcopter
to move left, then rotate quadcopter 90 degrees clockwise, and then moving aileron stick right that will
cause quadcopter to move right. Then rotate quadcopter 180 degrees and fly to left side.
You also can move elevator stick forward that will cause quadcopter to move forward, then rotate
quadcopter 180 degrees clockwise, then make quadcopter fly backwards to you. Then rotate
quadcopter 180 degrees clockwise and make quadcopter fly forward to you.
After practicing as above, you will get to know the basic flight knowledge. But it needs time to
practice, the more time you spend practicing the easier things will be on. Every practice is a different
challenge that brings you a lot of fun!
Good luck and enjoy your flying!
13
Before calibration, put the quadcopter on a horizontal surface. Connect mobile device to quadcopter and
enter into control interface. Then click the 09 Calibration. After that the quadcopter tail indicator LED light
begin to flash. When LED light turns to solid on, calibration ends.
After taking off, if there is no external interference(for example wind blows ), the quadcopter
should hover stably in small range without too much moving. If quadcopter moves to some direction
in big range, hovering trim is necessary
Firstly, fly the quadcopter at the height about 1 meter in the air. Then release both Left operating
stick and Right operating stick and observe quadcopter's moving direction. Click 09 Trim to enter into
trim mode. If quadcopter moves forward, move the elevator stick backward a little and quadcopter will
slow the moving forward. Keep moving the elevator stick until quadcopter hovers stably in small
range. At last, click 09 Trim to save.
10.Acceleration sensor calibration by APP
11.Hovering trim by APP
GALAXY VISITOR 7
NE-MASF25
Summary of Contents for Galaxy Visitor 7
