6
7 mm
72
ENGLISH
223 mm
142 mm
The purpose of these default settings is to enable a starting position to be traced after servicing has been
carried out.
1
The dimension, according to
the figure, must be
223mm
measured from the bottom
of the nuts (1)
to c/c shaft.
CAUTION: check both sides.
2
The length of the large spring
at the correct tension must be
142 mm.
3
The dimension from the end
of the threaded bar to the nut
must be 7mm.
CAUTION: check both sides.
Right-hand side
8 Default settings
Centr
e of sha
ft
Bott
om of n
ut
8.1 Spring tension