20
PARAMETER ADJUSTMENT
INTRODUCTION
The drying cabinet is equipped with two automatic programmes,
Normal
and
Extra
Dry.
The automatic programmes end automatically when the washing is dry.
To decide when the washing is dry, a measured value is compared with a factory-set
parameter, parameter
P 2072 for automatic programme normal dry
and para-
meter
P 2071 for automatic programme extra dry.
It is primarily these two parameters that are adjusted to optimise the drying process
of the automatic programmes.
p
If you find that washing is not dried sufficiently in:
Automatic programme normal dry,
the parameter value for
P 2072
is reduced.
Automatic programme extra dry
, the parameter value for P
2071
is increased.
p
If you find that washing is over- dried, long drying time in:
Automatic programme normal dry
, the parameter value for
P 2072
is increased.
Automatic programme extra dry
, the parameter value for
P 2071
is reduced.
Optimisation of the drying process must always take place in small steps, start by
adjusting the parameter concerned by 1-2 units up or down, then check the result
after the next drying process and if appropriate make a further adjustment.
PARAMETER ADJUSTMENT
The drying cabinet’s parameter list is accessed through the control panel. The para-
meter list is shown as follows:
on the top row of the display the current value is
shown,
e.g.
P
2071,
on the bottom row the set value of the parameter
is
shown.