Nimco WK-300-1-0, Manual

Page: 10 / 16

Series CV 652
Directional Control Valve
10
Black grip only
11375-3S WKG-1-0 Handgrip without el. switch
11453-3S WKG-1-1 Handgrip with 1 el. switch
11454-3S WKG-1-2 Handgrip with 2 el. switches
11455-3S WKG-1-3 Handgrip with 3 el. switches
Electric exchange plates for Black Grip
11374-4K WKEP-1-0 Plate without el. Switch
11515-4S WKEP-1-1 Plate with 1 el. switch
11516-4S WKEP-1-2 Plate with 2 el. switches
11517-4S WKEP-1-3 Plate with 3 el. switches
S-Grip grip only
11347-3S WKG-2-0 Handgrip without el. switch
13948-3S WKG-2-1 Handgrip with 1 el. switch
13949-3S WKG-2-2 Handgrip with 2 el. switches
13950-3S WKG-2-3 Handgrip with 3 el. switches
Electric exchange plates for S-Grip
11970-4k WKEP-2-0 Plate without el. Switch
12023-4S WKEP-2-1 Plate with 1 el. switch
12024-4S WKEP-2-2 Plate with 2 el. switches
12025-4S WKEP-2-3 Plate with 3 el. switches
Handgrips
Assembly Instructions – WK300 S-Grip
1
2
3
1. Place the two spacers in the desired position.
2. Pull out the security lock and draw the cables through the two holes in the housing.
3. Insert the cable joints and the pivot post in the yoke.
4. Push the cable joints and pivot post down into the housing.
5. Fasten the pivot post by assembling the screw and tightening it to 6-7 Nm using a 5 mm Allen wrench.
6. Lock the cables by tightening the two stop screws with 3-4 Nm using a 4 mm Allen wrench.
7. Minimum bending radius of cables is 150 mm.
8. Do not mount the cables with steel brackets, use cable clamps and do not deform the casing of the cable.
4
5
6 -7 Nm
6
3-4 Nm
R ≥ 150mm
7
8