2.16.2.2.
NL-SW-LTE-WM14
To test NL-SW-LTE-WM14, follow this procedure:
In the terminal program, type the command:
AT+CEREG?
followed by the Enter key, and the terminal should respond with:
+CEREG: 2, 1, xxxx, yyyyyyyy, z
For all other responses, review network status responses online in your
respective AT Commands Manual.
2.16.2.3.
NL-SW-LTE-QBG96
For NL-SW-LTE-QBG96 Skywire Modems:
In the terminal program, issue the following command:
AT+CEREG?
The modem should respond with:
+CEREG: x,1
Where
x
indicates the state of the
+CEREG
unsolicited response code, and
1
indicates that the modem is registered to the home network. The modem may
also respond with:
+CEREG: x,5
Which indicates that the modem is registered, and roaming on the cellular
network.
For all other responses, review network status responses online in your
respective AT Commands Manual.
For information on the
+CEREG
URC, please refer to the AT command manual
on the QBG96 product page.
Reset power, and repeat steps 2.5 through 2.15 (as applicable)
before moving on to Section 4.
PN 30005 rev 23
© NimbeLink Corp. 2019. All rights reserved.
25
