PN 30192 rev 8
© NimbeLink Corp. 2018. All rights reserved.
19
Using higher baud rates in Windows and Linux does not appear to be an issue as of the
publication of this document.
5.4 Network Registration
If your Skywire is not registering on the network, ensure that you have the antenna
connected to the correct port on your Skywire and NB1DK according to Section 2.2.4. In
addition, please make sure that you are setup to automatically register on the network
by checking the auto-attach settings in Section 4.12. Make sure you are getting an
acceptable signal strength according to Section 4.13. Finally, make sure that you typed
the APN correctly according to Section 4.10.
If the Skywire does not automatically register on the network, check the status of the
attachment by typing the following command:
AT+CGATT?
followed by the Enter Key, and you should see:
+CGATT: x
OK
where
x
is either
0
(not attached) or
1
(attached). If the result is
0
, type the command:
AT+CGATT=1
followed by the Enter Key, and the terminal should respond with:
OK
Return to Section 4.14 and continue from there.
