USER MANUAL
ENGLISH
SR 1101 B
1464015000(1)2009-04 A
17
MAIN BROOM HEIGHT CHECK AND
ADJUSTMENT
NOTE
Brooms of various hardness are available. This
procedure is applicable to all types of brooms.
Check the main broom distance from the
fl
oor as shown
1.
below:
Drive the machine on a level
fl
oor.
•
Keep the machine stationary, lower the main broom
•
and turn it on for a few seconds.
Stop and lift the main broom, then move the machine
•
and switch it off.
Check that the main broom print (A, Fig. 2), along its
•
length, is 2 to 4 cm wide.
If the print (A) is not within speci
fi
cations, adjust the broom
height as shown in step 2.
Engage the parking brake.
2.
Turn the ignition key (72) to “0”.
3.
Open the hood (7).
4.
Loosen the knob (A, Fig. 3) on the left side of the machine.
5.
Turn the knob (B), and remind that:
6.
It must be screwed to lift the broom;
•
It must be unscrewed to lower the broom.
•
After the adjustment, hold the knob (B) and tighten the
knob (A).
Perform step 1 again to check the proper adjustment of the
7.
main broom height.
When the broom is too worn out the adjustment is no more
8.
possible; replace the broom according to the instructions in
the next paragraph.
CAUTION!
If the main broom print is excessive (larger than
4 cm), the machine regular operation is affected
and the moving or electrical parts can overheat,
thus reducing machine life.
Pay careful attention when performing the above-
mentioned checks, and always use the machine
according to the indicated conditions.
A
2 - 4 cm
0,8 - 1,6 in
S311389
Figure 2
A
B
S311390
Figure 3
