USER MANUAL
ENGLISH
9099644000 - SCRUBTEC 343.2
13
Squeegee lifting
Lift the squeegee as indicated below:
1. Grasp the handlebar (2), lower it until the rear wheel (7)
touches the floor (A, Fig. 1) then engage the squeegee in
lifted position (B).
A
B
clik
Figure 1
P100642
MACHINE OPERATION (SCRUBBING/DRYING)
1. Start the machine as shown in the previous paragraph.
2.
While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the floor.
3.
If necessary, adjust the solution quantity by using the push-button (54).
CAUTION!
To avoid damaging the floor surface, do not use the brush without the solution and, when the machine is not
operating, stop the brush/pad-holder by releasing the push-buttons (51).
CAUTION!
Before lifting the brush/pad, turn it off by releasing the push-buttons (51).
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Nilfisk Alto suggests to go near the walls with the right side
of the machine as shown in figure 2.
A
A
B
Figure 2
P100643
Machine speed adjustment
4.
The machine speed varies according to the type of floor to be cleaned and the choice of using the brush or the pad. If
necessary, it is possible to adjust the machine speed, according to the procedure shown in Maintenance chapter.
Summary of Contents for SCRUBTEC 343.2
Page 83: ......
