12
POSEIDON PE
Original Instructions
5 After using the washer
5.1
Stop the pressure washer
1.
Stop the engine.
2. Close the tap.
3. Operate the spray gun until
the wasser is depressurized.
4. Lock the safety catch.
Switching off POSEIDON PE
with electric start
1. Stop the washer by moving
the throttle lever to STOP
position.
2. Switch off the ignition by
turning the key to OFF
position.
5.2 Disconnecting
supply
lines
1.
Shut the fuel cock.
2. Remove the water hose from
the washer.
5.3
Storing the washer
(frost-protected)
1. Store the pressure washer in
a dry room without danger of
frost.
IMPORTANT!
If the high-pressure washer
is stored in a room with
temperatures around or
below 0°C, anti-freeze should
be drawn into the pump
beforehand:
1. Remove the water inlet hose
from the washer.
2. Remove the lance.
3. Start the washer and stop it
again after max. one minute.
4. Connect the suction hose
to the water inlet of the
washer and place it in a tank
containing anti-freeze.
5. Start the washer.
6. Hold the spray gun over the
tank containing anti-freeze
and activate it to start suction
of anti-freeze.
7. During suction operate the
spray gun two or three times.
8. Lift the suction hose from the
tank containing anti-freeze
and activate the spray gun to
pump out the remaining anti-
freeze.
9. Stop the washer.
Summary of Contents for POSEIDON 2-35 PE
Page 1: ...106169306 Operating instructions POSEIDON PE...
Page 19: ......
