Nilfisk-Advance MC 2C 160/740 PET, Instructions For Use Manual

Page: 14 / 25

1)
Optional accessories / Option depending on model
Original instruction
14
Checking the oil level
F1 • Check whether the oil level is in the middle of the oil
F2 inspection glass, oil cup or dip stick. Top up with oil if
F3 necessary. (MC 2C, 7P does not have oil stick. MC 2C
does not have inspection or dip stick).
Changing the pump/gear oil (does not apply to MC 2C, 7P)
F4 1 Before changing the oil, allow the pressure washer to
F5 become warm.
2 Unscrew/open the plugs/lid at the top and the bottom of
the pump.
3 Allow the oil to drain into a suitable container
(min. 1 l capacity) and dispose of oil in compliance with
regulations.
4 Mount plug at the bottom of the pump.
5 Fill pump with fresh oil.
6 Check the oil level.
Replace the battery
F6 1 Disconnect the battery poles:
F7 – (black) first and then +(red).
2 Loosen the battery clamps/holders.
3 Remove and dispose battery according to local
regulations
4 Replace it with an original battery or one with the same
specifications.
5 Tighten the battery clamps/holders.
6 Connect the battery poles:
+ (red) first and then – (black).
Maintenance plan
weekly every six
months or
500 operating
hours
as required
Clean water filter ●
Clean high pres-
sure nozzle
●
Check oil level ●
Change oil - Note:
First time after 50
hours
●
Accessories
MC 2C
160/740 PET
MC 3C 180/750
PET
MC 4C 210/770
PEXT
MC 5C 240/940
PE
MC 5C
280/1000 PE
Hose reel
Option
107144825
Option
107144825
Standard
Option
107144825
Option
107144825
Gun-Lance holder
Standard Standard Standard Standard Standard
Hose length
M 10 (DN6) 10 (DN6) 15 (DN6) 10 (DN8) 10 (DN10)
Lance
4in1 4in1
FlexoPower
Lance 96cm
FlexoPower
Lance 96cm
Tornado Lance
100cm
Wheels
Flat Free Flat Free Flat Free Flat Free Flat Free
Battery
- - - - -
G
Further information
Recycling the pressure washer
If the pressure washer is discarded, make it unusable im-
mediately.
• Dismount the ignition plug.
The pressure washer contains valuable materials that
should be recycled. Contact your local waste disposal
site. If you have any queries, please contact your local
authorities or your nearest dealer.
Guarantee
Your Nilfisk product is guaranteed for 12 months from date of
purchase (purchase receipt must be presented) on the
following conditions:
• that defects are attributable to flaws or defects in
materials or workmanship. (Usual wear and tear as well
as misuse are not covered by the guarantee).
• that repairs have not been carried out or attempted by
other than Nilfisk-trained service staff.
• that only original accessories have been applied.
• that the product has not been exposed to abuse such
as knocks, bumps or frost.
• that the instructions in the manual have been carefully
observed.
A warranty repair comprises the replacement of defective
parts, but it does not cover freight and packaging charges.
Besides we refer to national Sale of Goods Act.
Any illegitimate guarantee repair will be invoiced. (I.e.
malfunctions due to causes mentioned in section
“Trouble shooting” of the instruction manual).