7 - FORM NO. 56041446 / DuraGloss
™
2000
MAINTENANCE
C - AIR FILTER
The air filter “A” on top of the motor should be cleaned at least once a week. To
clean the filter, slide the motor cover “B” forward and lift up and off. Pull the filter
off and wash with warm water and allow it to dry completely before putting it back
on the machine (or blow clean with compressed air).
D - DUST COLLECTION BAG
The dust collection bag should be removed and replaced after about every 10
hours of use. Tip the machine back onto it’s handle, the same as you would if you
were changing the pad. Squeeze in on the sides of the bag cover “A” and remove
it from the machine. Remove the dust bag “B” (being careful not to spill any
debris) and discard. Tip the machine back upright. Push in on the sides of the
new bag “B” to pop-it-open and install it by pushing it down (grip the cardboard
base of the bag) onto the (2) tubes protruding from the base. Re-install the cover
“A”.
MOTOR BRUSHES
This machine is equipped with a motor brush wear indicator light. If this light
comes on during use, contact your local Kent distributor to have the motor
serviced.
CAUTION!
The motor can be severely damaged if the machine is used for an extended
period of time with the light glowing.
TROUBLESHOOTING
SWIRL MARKS
•
Floor not clean.
•
Area not properly swept - debris in pad or brush.
•
Improper pad or brush for the job.
•
Moving the machine too fast.
CIRCLES ON THE FLOOR
•
Machine standing still while the brush or pad is running.
FLOOR FINISH REMOVED
•
Improper pad...too aggressive.
•
Moving the machine too slowly.
MACHINE WOBBLES DURING OPERATION
•
Defective pad... one side is more dense than the other.
•
Machine left sitting on brush or pad for extended period of time causing
bristles or pad to “take a set”.
•
Pad not “seated” properly into pad holder bristles.
•
Warped block on brush or padholder - replace.
MACHINE DOES NOT RUN
•
Check plug for proper connection - on machine and at wall outlet.
•
Check building circuit breaker.
•
Call for service.
TECHNICAL SPECIFICATIONS (as installed and tested on the unit)
Model
DuraGloss 2000
Model No.
56201902
Motor
1.5 hp, 120V
Transmission
Direct Drive
Pad / Brush Speed
2,000 RPM
Pad / Brush Size
20” (51 cm)
Wheels
5” (13 cm)
Cord Length
75’ (23 m)
Base Width
25” (63.5 cm)
Height w/Handle
48.5” (123.19 cm)
Net Weight (with pad holder)
84 lbs / 37.8 kg
Construction:
Handle Tube
Extruded Aluminum
Upper Handle
Injection Molded Polypropylene
Base
Roto Molded Polyethylene
