Nilfisk-Advance Captor 4300B, Instructions For Use Manual

Page: 20 / 60

A-20 - FORM NO. 56041577 - Captor
™
4300B, 4800B / CR 1100B, 1200B
A-20 / ENGLISH
AFTER USE
1 Raise the squeegee, the scrub brushes, and the brooms.
2 Shake the dust control
fi lter and empty the hopper.
3 Drain and fl ush the recovery tank.
4 Tip the recovery tank out and check the squeegee hose elbow below the tank for debris. DO NOT run water down the recovery tank
vacuum tubes, this may cause damage to the vacuum motors.
5 Remove and clean the squeegee tool.
6 Remove and clean the scrub brushes. Rotate the scrub brushes.
7 Wipe the machine with a damp cloth.
8 Perform all required maintenance before storage.
9 Move the machine to a clean, dry storage area.
10 Store the machine with the brooms, the squeegee and the scrub brushes in the UP position, and the tank covers open so that the tanks
can air out.
REPORT ANY DEFECT OR MALFUNCTION NOTED DURING OPERATION TO AUTHORIZED SERVICE OR MAINTENANCE
PERSONNEL.
MAINTENANCE SCHEDULE
Keep the machine in top condition by following the maintenance schedule closely. Maintenance intervals given are for average operating
conditions.
Machines used in severe environments may require service more often.
25 150 300 Yearly
MAINTENANCE ITEM Daily Hours Hours Hours (1,000hrs)
Charge Battery X
Drain / Check / Clean Tanks & Hoses X
Check / Clean / Rotate Scrub Brushes & Pads X
Check / Clean / Adjust Squeegee X
*Check / Clean Vacuum Motor Inlet Screen Cap X
Clean Solution Filter (32) X
Check Battery Cell Water Level(s) X
Check Foot/ Parking Brake For Wear & Adjustment X
Inspect Broom Housing Skirts X
Check Hydraulic Fluid Level X
Check / Clean Hopper Dust Control Filter Using Method “A” X
Inspect Scrub Deck Skirts X
Main Broom Maintenance X
Side Broom Maintenance X
Purge Detergent System (AXP/EDS only) X
** Lubrication X
Inspect Main Broom Upper & Lower Belts X
Check / Clean Hopper Dust Control Filter Using Method “B” X
Check / Clean Hopper Dust Control Filter Using Method “C” X
Replace Hydraulic Oil & Filter X
*** Check Carbon Brushes X
Have Nil fi sk-Advance service center inspect the wheel drive gearbox X
* DO NOT run water down the vacuum tube in the recovery tank this will damage the vacuum motors. Vacuum tube is on left side of tank with
screen cap.
** If the machine is being used in a very dusty or wet environment the lubrication should be performed once per week.
*** Have your Nil fi sk-Advance Dealer check the carbon motor brushes once a year or after 300 operating hours.
NOTE: Refer to the Service Manual for more detail on maintenance and service repairs.
revised 11/07