9 - FORM NO. 56041422 - AquaSpot
™
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
WARNING !
To reduce the risk electric shock or injury, unplug the power cord before servicing.
1
Toggle the Power Switch (15) to the MIDDLE position to turn both the vacuum motor and the solution pump OFF.
2
DISCONNECT THE POWER CORD (13).
3
Move the machine to a designated waste water “DISPOSAL SITE”.
4
Disconnect the Hose Assembly (6) from the machine.
5
Unstrap the Latches (2) and lift the Recovery Tank (4) from the machine.
6
Remove the Recovery Tank Lid (3), empty the tank and rinse with clean water.
7
Tip the Solution Tank (1) over to empty unused water or solution. Rinse the tank thoroughly if any cleaning chemical was used.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
MAINTENANCE SCHEDULE
MAINTENANCE ITEM
DAILY
WEEKLY
YEARLY
Clean the Hand Tool
X
Check the Power Cord for Damage
X
**Flush Pump System
X
Clean the Vacuum Motor Filters
X
*Check the Vacuum Motor Brushes
X
*Have Nilfisk-Advance check the carbon motor brushes once a year or after 500 operating hours.
**If you use cleaning chemicals in the Solution Tank (1) the pump system should be flushed clean after each use.
8
Store the machine indoors in a clean, dry place. Keep from freezing. Leave the tanks open to air them out..
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
FLUSHING PUMP SYSTEM
1
Move the machine to a designated waste water “DISPOSAL SITE”.
2
Fill the Solution Tank (1) with clean hot water.
3
Plug the machine in and toggle the Power Switch (15) to the UP position.
4
Pull and hold the trigger on the Hand Tool (7) until all of the water has emptied from the tank.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
VACUUM MOTOR MAINTENANCE
Once a month, check the vacuum motor to make sure the airways are not blocked. Clear hose of debris and keep the vacuum motor exhaust area
clean.
Have Nilfisk-Advance check the carbon motor brushes once a year or after 500 operating hours. Replace the carbon brushes if they are worn to
3/8” (9.5 mm) or less.
IMPORTANT !
Motor damage from failure to service the carbon brushes is not covered under warranty.
AFTER USE
revised 2/01