B-10 / ENGLISH
B-10
- FORM NO. 56041655 - UHR 70-1700
AFTER USE
1
Raise the Pad Drive Deck
(1)
, then drive the machine to a service area.
2
Turn the Master Key Switch
(A)
OFF (O) and remove the key.
3
Remove the burnishing pad, rinse the pad with warm water and hang it up to dry.
NOTE:
Allow pad to dry completely before using again.
4
Check the Dust Collection Bag
(5)
if over half full or damaged remove and replace with a new bag.
5
Check the maintenance schedule and perform any required maintenance.
6
Wipe the machine with a damp cloth, then store the machine in a clean, dry place.
MAINTENANCE SCHEDULE
MAINTENANCE
ITEM
Daily
Weekly
Monthly
Yearly
Charge
Batteries
X
Check/Clean/Replace Burnishing Pad
X
Check/Replace Dust Collection Bag
X
Check Battery Water Level(s)
X
Check/Replace Pad Shroud Skirt
X
Steering
Chain
Tension
X
Lubrication
X
Clean all dust and debris from the pad drive motor
X
Check Carbon Brush Wear On Pad/Wheel Drive/ Actuator Motors
X
NOTE:
Refer to the Service Manual for more detail on all maintenance items mentioned in this manual.
LUBRICATING THE MACHINE
Locations requiring periodic oiling are:
Qty 1 - Steering Wheel Shaft Universal Joint (oil hole or port)
STEERING CHAIN TENSION
Inspect once a month and make adjustments if needed (refer to the service manual for detailed instructions).
FIGURE 4
ELECTROMAGNETIC BRAKE
See Figure 4.
The Drive / Steer Wheel Assembly
(14)
has a built in electromagnetic brake that
is engaged whenever the Master Key Switch
(A)
is OFF or the FWD / REV Drive Pedal
(8)
is in
the neutral position. This brake can be manually over ridden if necessary by inserting a medium
to large screwdriver behind the Yoke
(AA)
as shown. This should only be done in the event you
need to push or pull the unit.
revised 8/13
