General Information
5
Service Manual – PBU Propane Floor Burnisher
General Safety Messages
Anyone operating the machine should read the following carefully and be informed of potentially dangerous
operating conditions Operators should be familiar with the location and use of all safety devices on the
machine Do not use the machine if it is not in proper operating condition, and report any damage or
operation faults immediately
Danger:
−
Never operate this machine without proper ventilation. It is the responsibility of the
machine operator, machine owner, and the site manager to ensure that the air exchange
system where the machine is to be used is in compliance with local building codes and is
operating properly. Failure to operate this machine in a well-ventilated area could lead
to sickness, injury, or death from carbon monoxide exposure.
−
This machine emits Carbon Monoxide (CO), which is colorless, odorless, non-irritating
gas. The first symptoms of CO exposure include headache, drowsiness, dizziness, and
nausea. If you should experience any of these symptoms while operating the machine,
shut off the machine and go outside to get fresh air. Have the machine tested for CO
emissions by a qualified service technician before using it again.
−
Prolonged or high exposure to CO may result in vomiting, confusion, and collapse in
addition to loss of consciousness and muscle weakness. If such symptoms occur, call
911 for emergency medical attention. If you have experienced these symptoms, DO NOT
operate this machine or any other propane machine again until cleared by a physician.
Excessive exposure to CO can result in death.
Warning:
−
Propane is a highly flammable fuel. Keep open flames and ignition sources away from
the machine and propane tanks. Do not store propane cylinders inside a building. If you
smell propane, shut off the machine immediately and take it outside the building.
−
Do not use a liquid withdraw propane cylinder or overfill a cylinder to cause it to supply
propane in liquid form. This machine is intended to use propane in vapor form. Liquid
propane will damage the system and poses a risk of fire. This machine uses a 20lb
(9.1kg) capacity aluminum or steel cylinder, which meets the DOT 4E240 standards.
Filling should be done only by a qualified propane dealer. Fill through the service valve
only. A properly filled cylinder should not exceed 80% of the rated capacity.
Caution:
−
Do not make unauthorized modifications or alterations to this machine. Nilfisk-Advance
assumes no liabilities for injury or damage resulting from an unauthorized modification
or alteration to the machine. Any unauthorized modification or alteration to this
machine voids all warranties.
−
To reduce the risk of burns, stay clear of the engine and exhaust until the machine has
cooled.
−
When servicing machine, stay clear of moving parts, and do not wear loose clothing.
Block machine wheels before raising or jacking up machine. Use hoist stands that will
support the weight of the machine. Wear eye and ear protection. Disconnect battery
connections before servicing machine. Use only Nilfisk-Advance authorized replacement
parts.
New & Reconditioned Equipment & Parts- www.southeasternequipment.net
New & Reconditioned Equipment - www.southeasternequipment.net
