8 -
Whirlamatic
Operator Manual
OPERATING THE MACHINE
1
Plug the Power Cord
(4)
into a properly grounded electrical outlet.
2
Pull the Handle Release Lever
(5)
UP and lower the Handle
(1)
to a comfortable operating position. It is normal for the
base of the machine to lift off of the floor slightly when the handle is lowered. It will pull itself down against the floor as
soon as the motor is started.
3
Push the Twist Grip Lock Button
(2)
IN and turn the Twist Grips
(3)
to start the motor. Release the Twist Grips to stop
the motor.
4
Push the machine forward in a straight line, at a slow walking speed. Overlap each pass about 1 inch (25 mm). Do not
use a back and forth motion when operating this machine.
5
When using a polishing pad, check every 15 minutes to see if the pad is loaded up with wax and dirt. If it is, turn the
pad over to expose the clean side, or install a clean pad.
AFTER USING THE MACHINE
1
Lift the Handle until it locks in the upright position.
2
Unplug the Power Cord and wrap it around the cord hook and the right Twist Grip.
3
Tip the machine back and remove the pad.
4
Wash the pad in warm soapy water, rinse completely and hang it up to dry. Do not use the pad again until it is completely
dry.
5
Store the machine in a clean, dry place.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
