Nilfisk-Advance 107146895, Service Manual, Page: 33 / 101

Construction
SM_MH 3M_4M Ver.1.2_May 2016 33
C
MH 3M & MH 4M Water Break Tank
Water break tank
Before removing the lid, the wires clicked into the
holders on top of the lid must be removed.
To remove the lid from the water break tank 4 clips
must be opened. 2 of the clips are shown on the
picture above
Now the lid can be removed from the water break
tank
If needed—in very dirty invironments—the 50 µm
(micron) water inlet filter can be installed over the
outlet point in the bottom of the water break tank.
When the lid is installed, the filter will be kept in
place. This will prevent impurities, that might enter
the tank through the overflow opening, ending up
in the pump.