When the device completes the internal self test, it shows the standby screen. If the arrow down is
displayed at the bottom right corner, the device has detected signal reception problems. In this case press
Page Down button to see possible solutions. Resolve the issue basing on the recommendations.(see
possible troubles and solutions below in Questions & Solutions paragraph)
If the problem is resolved, the screen will display as below. No arrow means that the repeater works
correctly:
LINE 1.
BS shows the level of outdoor incoming signal for the corresponding frequency band. Make sure it
is as low as possible.
Note! For the optimal functioning of the booster, the BS (input) index should be from -65 to -50 dBm. If the
BS is lower than - 65dBm, the coverage will be smaller. However, the device can work normally. If the BS is
too weak, it'll be necessary to adjust the position of the outdoor antenna by raising it as high as possible
(on a pole on the rooftop) and pointing it towards the provider's nearest base station.
If the BS is higher than - 50 dBm, the device will have self-excitation issue. In such cases, the output signal
will drop during communication. If the antennas are placed very close to each other, it will evoke self-
excitation. To fix the problem, you would need to place the outdoor antenna at thelargest possible distance
from the indoor antenna.
LINE 2.
MS shows the output power of a booster.
Note! The MS (output power) index must be b05 and +15 dBm. Device Gain must be 65/65 dB.
LINE 3.
Device gain shows the current gain (left) and maximal gain (right) of the device. For optimal
function both values must be equal (current gain=max gain).
Line 4 shows that power supply is connected and works properly (DC5V) and automatic gain control of the
system is also active (AGC).
LINE 4.
Power DC 5V shows that power supply is connected and works properly. AGC function for
automatic gain adjustment.
Note! In LINE 4 in its right corner can appear the exclamation point or an arrow. It denotes an installation
error. Use UP and DOWN buttons to see the reasons. For more details, read the section QUESTIONS &
SOLUTIONS.
Summary of Contents for LCD-1200GW
Page 7: ......
