1.
2.
3.
To install the indoor motion detector:
Connect the base to the two-wire bus cable. There are two “B1” contacts and two “B2” contacts at the back of the base. Connect
each individual wire to one “B1” contact and one “B2” contact.
The base is now connected. Use the other “B1” and “B2” contacts to establish a connection to the next control element if required.
Mount the base onto the single flush-mounting box using screws. Use a base with a set of claws if no screw holes are provided in
the flush-mounting box. Two types of bridges are available:
base 60 x 71 mm with claw connection (Belgium)
base 71 x 71 mm with screw connection (the Netherlands)
Press the sensor onto the base until it clicks into place.
Selecting the indoor motion detector settings
Setting the light sensitivity
The indoor motion detector is for indoor use only.
Mount the indoor motion detector at 90 - 110 cm above floor level.
The maximum detection range is 8 m.
Strip the wires of the bus cable 9 - 10 mm.
A maximum of one wire with a diameter of 0.5 - 1 mm can be connected per contact.
In this case, polarity does not matter.
