9
10-821-01
Read the complete manual before attempting installation and activating the
system.
1. DESCRIPtIoN
The video splitter 10-821-01 enables the video signal of a Access Control Standard system
to be split up and amplified in order to build bigger video installations. The video splitter
10-821-01 is used for splitting the video signal per floor in rising mains (fig.1). The video
splitter receives the video signal and splits it up in two separate video output signals.
Which cables are required?
Niko recommends the following:
- JYSTY(-F2) min. 3 x 2 x 0.8mm
- TVVF (-F2) min. 3 x 2 x 0.8mm
- TPVF min. 3 x 2 x 0,6mm (Limits the number of components to be connected. For
specifications, see technical catalogue).
Note: A cable with 4 (twisted) pairs has the advantage of offering sufficient spare pairs
in case one pair is damaged.
2. INStaLLatIoN aND CoNNECtIoN
Video splitter 10-821-01 (fig.1a) is suitable for mounting in a flush mounting box. For the
connection of the bus and the video signal, see fig.1 and fig.2.
➊
connection terminals input signal
➋
J1: terminal resistor
➌
J2: 5/6-wire cabling
➍
control video image clarity
➎
connection terminals video output 1
➏
connection terminals video output 2
Limit values for rising mains:
- Max. 15 video flush mounting splitters
2 (10-821-01) can be connected in line
(in-out).
Note: the last video flush mounting splitter in line has to be closed off by means of a
terminal resistor.
- Max. 30 video internal units per power supply 10-805-01.
- At every video output of a video flush mounting splitter 2, max. 6 video internal units
can be connected in line (in-out).
Note: for large and complex systems, please contact Niko.
EN
IN
Video
OUT1
Video
OUT2
Video
V1
V2
V1
V2 V1 M P b a
V2
6
ON
OFF
5
J1
J2
10-821-01
1.0
➊
➋
➌
➍
➎
➏
Summary of Contents for 10-821-01
Page 15: ...15 10 821 01...
