5
1
2
3
English
VEHICLE
Use a coin to turn the battery stopper to the
"OPEN" position.
Install the Ni-Cd battery pack into the battery
compartment of the vehicle.
Replace the battery stopper
.
Ni-Cd battery energy pack(6.0V)
battery stopper
Steering alignment lever
1
2
3
**
**
*
To remove the Ni-Cd battery pack:
Turn the battery stopper to the "OPEN"
position using a coin.
Slide the Ni-Cd battery pack backward and
take out.
2 HOW TO OPERATE
Turn ON the vehicle.
Operate the vehicle with transmitter.
Turn OFF the vehicle after operating.
Remove all the batteries both from the vehicle
and the transmitter.
Please follow the above sequence of operation.
1
2
3
4
ON/OFF switch
**
**
*
TRANSMITTER
Antenna
Speed control stick
Steering control stick
LEFT/STRAIGHT/RIGHT
FORWARD
NEUTRAL
REVERSE
VEHICLE
Check to see that the battery is INSTALLED in the CORRECT position.
NOTE:
You can control the vehicle at a longer distance by holding the trans-
mitter higher with the antenna straight up.
When the vehicle slows down or starts moving erratically, replace the
vehicle's battery pack with fresh or fully charged one.
STOP
Auto Power Off Function of the Transmitter
(PAT.P)
If the user does not operate the transmitter, or
performs a single operation continuously (the con-
trol stick of the transmitter is fixed to one position -
forward, reverse, left turn, or right turn - and oper-
ated continuously) the transmitter power will be
turned OFF automatically in about 3 minutes.
This is to prevent the battery power from running
out in case, for some reason, the transmitter
should be left intact with the control stick in opera-
tion.
If the power is turned off automatically, return the
control stick to the stop position (the position to
which the control stick returns when hands are
off). You will be able to start operating again.
