Page: 6
p
1. Roughen up the tube with sand paper to
give the glue something to bite into.
p
2. Glue the tube to the motor mount. Cut a
little covering away so glue can bond to the
wood.
p
3. Add some weight to keep it straight with
the building board.
p
4. Cut two slots in the non-exhaust side
3/16" wide x 1" long. Cut slot starting at 4
¾" from front of the tube and ending at 5
¾”. Rear slot starts ~6” from end of tube
and ends ~7", but placement is not critical.
p
5. Using poly glue for this part really makes
a strong bond and expands to fill any gaps.
p
6. Squirt a little poly glue in hole where the
wing tube comes thru the wing. Use a heat
gun to get it to run down the hole some.
