EQUIPMENT MANUAL:
MODELS DA118 and DA120 PPM 360 Meter
Document #: 1050-xxxx
Revision: B
CONFIDENTIAL AND PROPRIETARY INFORMATION
Copyright © 2015 The Nielsen Company. All rights reserved.
12
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Contact Nielsen Audio, Inc. for help.
Changes or modifications not expressly approved by Nielsen Audio, Inc.
could void the user’s authority to
operate the equipment.
Radio Frequency Exposure Information (SAR)
This equipment meets the U.S.
government’s requirements for exposure to radio waves. The
exposure standard for wireless devices employs a unit of measurement known as the specific
absorption rate, or SAR. The SAR limit set by the FCC is 1.6 watts per kilogram (W/kg). Tests for SAR
are conducted using standard operating positions accepted by the FCC with the device transmitting
at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of the
device while operating can be well below the maximum value. This is because the device is
designed to operate at multiple power levels so as to use only the power required to reach the
network. In general, the closer you are to a wireless base-station antenna, the lower the power
output.
The highest measured SAR value for this device when worn on the body as described in this user
guide is 1.54 W/kg. Additional SAR information for this device can be retrieved by accessing the
FCC Equipment Authorization search page at http://www.fcc.gov/oet/ea/fccid/ and entering the
Following; FCC ID: IGK-DA118A or FCC ID: IGK-DA120A depending on the specific device model.
The FCC ID for each device model is shown on the device equipment label.
For body worn operation, this device has been tested and meets the FCC RF exposure guidelines
when used with the belt-clip accessory provided by Nielsen Audio. Use of other accessories may not
ensure compliance with FCC RF exposure guidelines.
IC (Canadian Industry) Notice
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
