Nielsen CT2880, Original Manual

Page: 7 / 32

4. UNPACKING
Carefully remove the product from the packaging and examine it for any sign of damage that
may have happened during shipping. Lay the contents out and check them against the parts
shown below. If any part is damaged or missing; please contact the seller and do not attempt
to use the product.
Keep the packing materials out of the reach of children. Handle in an appropriate way if the
packing material is likely to cause pollution.
Remove the cabinet, column, swing arm and accessory box fitted on the bottom plate and
keep them in safety place.
5. INSTALLATION AND ADJUSTING
The place to install the machine should be in
accordance with safety regulations
：
• The machine should be installed in a place
close to the main power source and
compressed air system.
•
Install the machine on smooth concrete ground
or other ground with hard flooring. 4 sets of
anchor bolts M10X150 can be used to fasten
the machine onto the ground to avoid vibration
and noise.
• Leave enough space for the operation and
maintenance of the machine. The space should
be no less than 1M in front and on the two sides
of the machine, 0.5M behind it so that operation
on different parts shall not be hindered.
•
If the machine has to be installed outdoors,
a protective shelter should be built.
•
Never operate the machine in a place with
flammable gas.
NOTE: For safety and proper operation,
keep the machine at least 0.5M away
from any wall.
Installation
Move the column C and arm D, put
them on a soft cushion.(Fig.4)
Caution
：
When you lift the column, the arm D will
fall freely, be careful!
Fig.3
Fig.4