34
WARNING:
Before taking any in-circuit resistance measurement, remove power from the circuit being tested and
discharge all the capacitors.
3.4. Resistance and Continuity Measurement23.4. Resistance and Continuity Measurement
a.
Set the rotary switch at
Ω
b.
Insert the test leads into the input jack.
c.
Connect the test prods of the test leads to the two ends of the resistor or circuit to be measured.
d.
Read the measured value from the LCD display.
e.
If the resistance is lower than 40
Ω
, a beeping sound shall be heard.
3.5. Relative Reading Measurements23.5. Relative Reading Measurements
The zero button also can be used to make a relative measurement. Once the button is pushed, the current reading is set to
zero and a zero symbol shall be displayed on LCD. All the subsequent measurement shall be displayed as a relative value with
respect to the value being zeroed. Press the zero button for 2 seconds to return to normal mode
3.6. Holding the LCD Reading
Press the HOLD button, then the reading shall be hold and kept on LCD.
Summary of Contents for NI 333
Page 1: ...1 AC LEKSTROOMTANG MULTIMETER NI 333 AC LEAKAGE CLAMP MULTIMETER NI 333 Handleiding Manual...
Page 6: ...6 Figuur 1...
Page 23: ...23 Figure 1...
Page 28: ......
