33
INTRODUCTION: Before First Use
2.4.6
Other preparations
1
Set the printer paper.
“2.4.5 Setting the printer paper” (page 31)
2
As necessary, insert a charged battery pack into the main body.
“2.4.1 Removing and installing the battery pack” (page 25)
3
Attach the occluder (R/L) to the main body.
The occluder is held in place by magnets as shown to
the right (R/L).
Covering the eye that is not being measured facili-
tates patient eye fixation.
When the occluders are not in use, place them on the
occluder base of the station.
4
As necessary, connect peripheral devices.
“3.11.1 Connecting peripheral devices” (page 82)
• If no printer paper is loaded, the error message “OUT OF PAPER” appears when
is pressed.
(This message does not appear while the device is communicating by infrared.)
Occluder
CAUTION
• When measuring a patient lying down, do not use the occluders.
The occluders may fall on the patient resulting in injury.
