31
INTRODUCTION: Before First Use
2.4.5
Setting the printer paper
The setting and replacement procedures of the printer paper are described here.
O
Setting the printer paper
1
Press
to open the printer cover.
2
Set the printer paper.
As shown to the right, set the roll levelly with its end
coming upward.
If the roll is loaded with the paper upside down,
printing is not possible.
If the roll is not level, printer paper may not be
properly fed.
3
Close the printer cover.
1)
Set printer paper so that its end extends from
the cover.
Hold down
to feed the printer paper.
2)
Press the printer cover on both sides to close
the cover securely.
CAUTION
• Be sure to use only the printer paper (80620-00001) specified by NIDEK. If printer paper other than
that specified is used, the printer head may be damaged due to printing failure or paper jam, or
printed contents may easily become illegible.
The end of the paper
Leave the end of the
paper.
CAUTION
• Be sure that the cover is securely closed.
If the cover is insecurely closed, the auto cutter may not operate properly.
In addition, when
is pressed, “OUT OF PAPER” may appear and printing does not start.
(This message does not appear while the device is communicating by infrared)
