①
②
③
■ Screw hole positions on measuring table
54 9
■ Slide height adjustment procedure
■ Force gauge mounting hole positions
57.5
Measuring table
FGC/FGN measuring axis center position
FGX measuring axis center position
160
6-M6
60
The mounting holes other than
those indicated by arrows are
intended for the DFG-0, and
DFG-2 to DFG-50 (old types).
FGX mounting hole position
3- φ 5.5
FGC/FGN mounting hole position
4- φ 4.5
Stand mounting hole
40
50
75
■ Stroke adjustment procedure
If height adjustment cannot be performed with the lever, 3-level 30 mm-step height adjustment is enabled by moving
the slide assembly.
① Lay the stand body with the side facing up. (Remove the cable grip beforehand.)
② Loosen the height adjusting bolts in three slots out of four. (Do not remove the bolts.)
③ While raising the slide assembly, remove the bolt from the small hole, and hold the slide assembly at an appropriate
position. Then, tighten the remaining three bolts.
In this step, be careful not to get your hand or finger caught between the slide assembly and the stand body.
The force gauge stroke can be adjusted with the lever.
The stroke adjusting range is 50 mm.
Summary of Contents for FGS-5S
Page 1: ...ASSY FGS 5S...
