16
Part # M017879450000 REV. July 1, 2011
ECOTECH EZ
TM
Variable Speed Motor/Control
D) mon-fri flow 2 programming
NOTE: Flow 1 settings take precedence over Flow 2 settings if Start Times are the same.)
1.
Use (up arrow) and (down arrow) to set the desired
flow %.
2.
Press the (right arrow). Use the instructions for Setting the
Clock to set the Time On and Time Off on this screen.
3.
Use the (left arrow) and (right arrow) to move through the
time and flow setting process. Use (up arrow) and (down
arrow) to increase or decrease Time and Flow.
4.
Press Enter when you are finished setting the desired
Flow 2 rate and times of operation. If you would like
to set flow rates for Sat-Sun, press ENTER. Follow the
directions for Mon-Fri Flow 1 & 2 programming to set
Sat-Sun programming. If not, proceed to # 5 below.
5.
Press Exit to run the stored program. Ensure the RUN/
STOP button is lit to run the program.
NOTE: In the PROGRAM menu, if no button is pressed within 30 seconds, the unit will EXIT and return to the RUN mode.
315612_MNJ26_VAR SPD_nonSRVS.indd 16
7/19/11 8:01 AM
