Nidec DT-3015P, Instruction Manual

Page: 8 / 40

7
3.2 Operation Panel
Ｎ
o. Key Function Instructions
①
Power Switch Turns the power ON / OFF
②
Dial (LAMP POWER)
Turn this clockwise or counterclockwise to change the emission frequency and some
setting value.
Press and hold the center of this to turn the lamp ON / OFF.
③
MODE
Press this to switch the LED display as follows
Flashes Per Minute mode (FPM mode)
→
Phase Shift mode (PHA mode DEG =
delay angle ) → Phase Shift mode ( PHA mode ms = delay time ) → FPM mode →…
④
LOAD(SAVE)
Press this to load the saved settings.
Also, Press and hold this to save the current display and mode settings.
⑤
SIG
Select Internal/ External/ Parameter mode.
Internal oscillation emission (
referred to as “INT” )
：
Flash by internal signal
External synchronous emission (referred to as “EXT”)
：
Synchronized flash with external
signal
⑥
UNIT
Each press of this switches the delay type as following,
delay angle(DEG) → delay time(ms) → DEG → ms
⑦
× 2
Press this while on INT to double the current set emission count (frequency).
(*If the double count is over than the flash range, nothing will change on the display.)
⑧
÷ 2
Press this while on INT to halve the current set emission count (frequency).
(*If the half count is lower than the flash range, nothing will change on the display.)
②
①
③
④
⑧
⑥
⑦
⑤