Nicols PAR LED 1418 Z IP, User Manual

Page: 11 / 18

1. SAFETY INSTRUCTIONS
WARNING
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive
this instruction booklet.
Caution
：

All fixtures are intact from the manufacturer, please operate follow up the user manual, artificial fault are not under
guarantee repair.

Unpack and check carefully there is no transportation damage before using the unit.

Do install and operate by operator.

Use safety chain when fixes the unit.

The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces.

Before operating, ensure that the voltage and frequency of power supply match the power requirements of the
unit.

It’s important to ground the yellow/green conductor to earth in order to avoid electric shock.

Maximum ambient temperature: 40 ℃ . Don’t operate it where the temperature is higher than this.

Don’t connect the device to any dimmer pack.

First run, there will be smoke or smells, and all disappearing a few minutes later.

Make sure there are no flammable materials close to the unit while operating, as it is fire hazard.

Look over power wires carefully, replace immediately if there is any damage.

Unit surface temperature may reach up to 60 ℃ . Don’t touch the housing bare-hand during its operation.

Never run on for a long time lest shortening lifespan.

Avoid any inflammable liquids or metal objects entering the unit. Once it happen, cut off the mains power
immediately.

The fixtures must be cleaned regularly if they are in a dirty and dusty environment

Do not allow children to operate the fixture.

Do not touch any wire during operation as there might be a hazard of electric shock.

Avoid power wires together arounding other cables.

Replace fuse only with the same type.

In the event of serious operating problem, stop using the unit immediately.

Never turn on and off the unit time after time.

Do not open the unit as there are no user serviceable parts inside. Never try to repair the unit by yourself. Repairs
carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized
technical assistance center.

Disconnect the mains power if the fixture is not used for a long time.

Do use original packing materials once transport it again.

Do not look directly at the LED light beam while the fixture is on.
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid
vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit is secure
and is able to support a weight of 10 times of the unit’s weight. Also always use a safety cable that can hold 12 times
of the weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out of the touch of people
and has no one pass by or under it.
Please read the instructions carefully which includes important
information about the installation, operation and maintenance.