2
SAFETY WARNINGS
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive
this instruction manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not accept liability for
any resulting defects or problems.
•
Unpack and check carefully that there is no transportation damage before using the unit.
•
DO install and operate by qualified operator.
•
DO NOT allow children to operate the fixture.
•
Use safety chain when fixing the unit. Handle the unit by carrying its base instead of head only.
•
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces.
•
Be sure that no ventilation slots are blocked, otherwise the unit will be overheated.
•
Before operating, ensure that the voltage and frequency of power supply match the power requirements of the unit.
•
It’s important to ground the yellow/green conductor to earth in order to avoid electric shock.
•
Maximum ambient temperature Ta: 40
℃
. DO NOT operate it when the temperature is higher.
•
DO NOT connect the device to any dimmer pack.
•
During initial start-up some smoke or smell may arise. This is a normal process and does not necessarily mean that
the device is defective, and it will decrease gradually within 15 minutes.
•
Make sure there are no flammable materials close to the unit while operating to avoid fire hazard.
•
Examine the power wires carefully, replace them immediately if there is any damage.
•
Avoid any inflammable liquids, agressive liquid or metal objects entering the unit. Once it happens, cut off the mains
power immediately.
•
DO NOT operate in dirty or dusty environment, do clean fixtures regularly.
•
DO NOT touch any wire during operation as there might be a hazard of electric shock.
•
Avoid power wires together twist other cables.
•
Disconnect mains power before fuse/lamp replacement or servicing.
•
Replace fuse only with the same type.
•
In the event of serious operating problem, stop using the unit immediately.
•
Never turn on and off the unit time after time.
•
DO NOT open the unit as there are no user serviceable parts inside.
•
Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center if needed.
•
Disconnect the mains power if the fixture is has not been used for a long time.
•
DO use the original packing materials before transporting it again.
Please read carefully the instruction, which includes important
information about the installation, usage and maintenance
User Manual
TX DMX WS IP
