Nice spido SP6000, Instructions And Warnings For The Fitter, Page: 5 / 42

3
GB
2.3) Limits of use
Sectional door (Max. H = 2400 mm) (fig. 4)
Counterweight up-and-over door (Max. H = 2400 mm) (fig. 4a)
Overhead spring up-and-over door (Max. H = 2600 mm) (fig. 4b)
2.4) Installing SPIDO
1. Connect the draw bar (27) to the curved bar (61) (Fig. 5) ;
2. Thread the cord (24) into the unthreaded hole of the release pin
and keep it flush at the other end;
3. Tie the two ends together after passing them through the hole in
the knob (25);
4. Insert the guide support bracket (32) into the chain tightening
device and fix it with the screw (48) and the nut (17) (Fig. 6) ;
5. Insert the slide (23) into the end of the profile (Fig. 7) ;
6. Insert the screws (35) into the two slots of the profile (Fig. 8) ;
7. Insert the profile by passing the chain over the motor pinion and
block it with the bracket (33) using two screws (44) (Fig. 9) ;
8. Tighten the chain slightly (Fig. 10) ;
9. Fix SPIDO to the frame of the door (recommended choice) or to
the wall with rivets or expansion grips keeping a distance of
between 30mm and 350mm from the maximum travel of the
door (Fig. 11) ;
10. Check the measurements for drilling the holes, insert and block
the support brackets (18) and fix SPIDO to the ceiling. Cut the
excess part of the bracket (Fig. 12) .
2.5) Adjusting the drive bar
In order to ensure fine adjustment in the closing manoeuvre, loosen
the bolts of the drive bar with a 10mm wrench and adjust the travel
using the two slots or, if necessary, completely unscrewing the bolts
and changing the fixing position (Fig. 13) .
Thoroughly tighten all the screw connections.
!
2.6) Fitting the limit switch slides
The limit switch slides may only be inserted when the
motor has stopped.
To fix the limit switch slides, follow the instructions referring to the
“electrical control unit”.
!
4 4b
4a