6.3 - Menu
Menu allows to perform Z-Wave network actions. In order to use the menu:
1. Press and hold the service button to enter the menu, device blinks to signal adding status (see 7.2: Visual indications).
2. Release the service button when device signals desired position with colour:
»
GREEN
- reset energy consumption memory,
»
YELLOW
- reset to factory defaults.
3.
Quickly click the service button to select, 2 blinks of the same colour will confirm the selection.
6.4 Resetting to factory defaults
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user
configuration will be deleted. Resetting to factory defaults does not reset energy consumption memory.
1. Press and hold the service button to enter the menu.
2. Release service button when the device glows yellow.
3.
Quickly click the service button to confirm.
4. After few seconds the device will be restarted, which is signalled with the red colour.
Note.
Resetting the device is not the recommended way of removing the device from the Z-Wave network. Use reset procedure only if the
primary controller is missing or inoperable. Certain device removal can be achieved by the procedure of removing described.
7
ACTIVATING SCENES
The device can activate scenes in the Z-Wave controller by sending scene ID and attribute of a specific action using Central Scene Command
Class.
In order for this functionality to work, connect momentary or toggle switch to the IN1-IN4 inputs and set parameters 20-23 to 2, 3 or 4 (de-
pending on type of switch).
Table A1 - Scene IDs for inputs
Input
Scene ID
IN1
1
IN2
2
IN3
3
IN4
4
Table A2 - Attributes for actions
Action
Attribute
Switch clicked once
Key Pressed 1 time
Switch clicked twice
Key Pressed 2 times
Switch clicked thrice
Key Pressed 3 times
Switch held*
Key Held Down
Switch released*
Key Released
* Not available for toggle switches.
8
ASSOCIATIONS
Association (linking devices)
– direct control of other devices within the Z-Wave system network.
Associations allow:
• reporting the device status to the Z-Wave controller (using Lifeline group),
• creating simple automations by controlling other devices without participation of the main controller (using groups assigned to actions on
the device).
Note.
Commands send to 2nd–10th association groups reflect inputs operation according to device configuration, e.g. turning the first chan
-
nel on using input will send frame responsible for the same action.
