EN
English -
10
transmitter already memorised. The procedure does not entail any direct action on key A of the receiver, only
the presence of the transmitter within the receiver’s reception range.
• The memorisation “near the receiver” can be prevented by blocking the receiver’s function through Procedure
7 (Paragraph 3.8). Alternatively, the receiver can also be blocked with the O-Box programmer.
PROCEDURE 3 - Memorising a new transmitter “near the receiver”
01.
On the NEW transmitter:
hold down the key to be memorised;
wait at least 7 seconds then release it.
x 7 sec
1
3
2
4
1
2
1
NEW
02.
On the transmitter ALREADY MEMORISED:
slowly press
and release
3 times
the memorised key to be copied.
1
3
2
4
1
2
1
OLD
03.
On the NEW transmitter:
press and release
once
the same
key pressed at step 01.
1
3
2
4
1
2
1
NEW
If there are other transmitters to be memorised, repeat the procedure from the beginning for each new
transmitter.
3.4 - Memorising a new transmitter using the “enabling code” of an old transmitter already memo-
rised in the receiver - only for transmitters with “O-Code” and “BD” encoding system
The memory of transmitters with O-Code and BD encoding contains an
“enabling code”
(secret) which can
be used to enable a new transmitter to be memorised in the receiver. To perform this enabling procedure, read
the transmitter’s instruction manual and get an old transmitter already memorised in the same receiver in which
the new transmitter is to be memorised. Warning! - The enabling code can only be transferred between two
identical transmitters that have the same radio coding.
Subsequently, when the new enabled transmitter will be used, it will send to the receiver (in the first 20 transmis-
