5
– English
EN
Align the adjustment screws with the respective limit positions:
02.
Stand in front of the shutter and note the following:
A
) – Stand in front of the roller and observe at which end the head of the motor protrudes:
at the right end or left end of the roller?
B
) – Stand in front of the roller and observe where the unrolled part of the rolling shutter is positioned:
is in front of or behind the roller?
03.
Then identify in figure the diagram that corresponds to situations “
A
” and “
B
” observed in point 02.
Very important – The identified diagram assigns a specific limit position to be set on each adjustment screw.
Setting limit position “0”:
04.
Activate the shutter so that it moves towards position “
0
” and wait for the motor to stop on activation of the limit switch pre-set with the factory settings.
Caution!
– If the shutter moves beyond the point at which limit switch “
0
” is to be fixed, stop movement and then activate the shutter to move it back
to the starting position; then turn the adjustment screw of limit position “
0
” through a few turns in the direction of the “
–
” sign and repeat the procedure
from point 04.
05.
Gradually turn the adjustment screw of limit position “
0
” in the direction of the “
+
” sign, to the required stop position “
0
”.
Note
– on each turn of the screw, the motor moves to stop in the new position.
Setting limit position “1”:
06.
Turn the adjustment screw of limit position “
1
” through a few turns in the direction of the “
–
” sign.
07.
Activate the shutter so that it moves towards position “
1
” and wait for the motor to stop on activation of the limit switch pre-set with the factory settings.
Caution!
– If the shutter moves beyond the point at which limit switch “
1
” is to be fixed, stop movement and then activate the shutter to move it back
to the starting position; then turn the adjustment screw of limit position “
1
” through a few turns in the direction of the “
–
” sign and repeat the procedure
from point 07.
08.
Gradually turn the adjustment screw of limit position “
1
” in the direction of the “
+
” sign, to the required stop position “
1
”.
Note
– on each turn of the screw, the motor moves to stop in the new position.
6
EMERGENCY MANUAL MANOEUVRE
The product is equipped with a mechanism fitted in the motor head (
fig. 8
) which enables the user to make an emergency manual manoeuvre by rotating the rod
in one direction or the other. To avoid premature wear of the mechanism, it should be used exclusively in the event of an emergency, such as a power failure.
CAUTION! – During this emergency manoeuvre, the shutter must NOT exceed the travel limits “0” and “1” set during product installation.
