A.4 - SEMIAUTOMATIC programming of the UP (“0”) and DOWN (“1”) limit switches
NOTES AND WARNINGS
• Use this procedure solely for awnings with mechanical Up “0” limit switch stop.
•
If the limit switches have been programmed using the manual procedure (A.3), before you can use this procedure you need to perform a total or partial deletion of
memory (A.8.1 option ‘A’ or ‘D’)”.
• After the limit positions have been programmed, the awning can be controlled by simply pressing the appropriate buttons on the control unit. The Up movement
will be limited when the awning impacts against the mechanical lock (box) in the Upper limit switch “0”. With each impact, the height of this limit switch will be au-
tomatically updated by the “Automatic limit switch update” function (paragraph 5.8). Conversely, the Down movement will be limited by the Lower limit switch “1”
(limit switch set by the installer at a desired point).
1
2
continues
Command
an UP
movement
“
0
”
Command
an DOWN
movement
Hold down the button and...
... wait for the awning to be stopped when it
collides with the box (= UP
limit switch
= po-
sition “
0
”).
release the but-
ton.
Hold down the button and wait...
2
3
4
5
“
1
”
(x
1
)
PRG
2
=
5
sec
2
... release the button as soon as the awning
reaches
position “1”
(
DOWN
limit switch).
Press and release
the button (
1 time
);
count 2 movements.
Hold down the but-
ton and
release it after
5 sec-
onds
;
count 2 movements.
5
6
end
Finely adjust-
ing the posi-
tion of limit
switch “1”
“
1
”
=
5
sec
3
Press the buttons until you reach the desired position.
Hold down the button and
release it after
5 seconds
;
count 3 movements.
A
A.3.2 - To program the DOWN limit switch (“1”)
1
2
3
continues
(x
1
)
PRG
2
=
5
sec
2
Command
an DOWN
movement
Press and release
the button (
1 time
);
count 2 movements.
Hold down the but-
ton and
release it after
5
seconds
;
count 2 movements.
Hold down the button and wait...
3
4
5
end
“
1
”
↕
Finely adjust-
ing the posi-
tion of limit
switch “1”
“
1
”
=
5
sec
3
... release the button as soon as the awning
reaches
position “1”
(
DOWN
limit switch).
Press the buttons until you reach the desired position.
Hold down the
button and
release it after
5
seconds
;
count 3 movements.
English –
8
Summary of Contents for E Fit M 720
Page 1: ...Nice KO E Fit M 720...
Page 2: ...Machinery Directive III A 70 dB A 0 4 m 1 8 m 1 5 m 2 5m 1...
Page 5: ...d M 10 mm e c a 4 f 1 2 g i h b 4...
Page 17: ...Nice EN Instructions and warnings for installation and use Tubular Motor E Fit M 720...
