Construction manual - Robot kit NIBO
burger
08.09.2015
Soldering should work like this:
Video „Soldering in 30 seconds“
http://www.nicai.eu/soldering
If it doesn't work as seen in the video, it can be useful
to check the own soldering equipment and/or get someones help.
The soldering time should be limited to a few seconds (not minutes!) for each
pad. Most electrical components react sensitively to high temperature.
For
very
sensitively components you can do the following:
First you solder 3-5 seconds, if the soldering point isn't good enough yet, you
let the component cool down and afterwards you solder again for 3-5
seconds.
The optical components (LEDs, IR-LEDs and phototransistors) are very
sensitively components.
Procedure:
First of all you have to insert the legs of the electronic part into the soldering
pads of the circuit board. On some parts you have to
pay attention
to the
polarity
.
That means that it is quite important which leg has to be connected
to which pad!
http://nibo.
nicai-systems.de
18
