©
National Instruments
2-1
2
Installation and BIOS Setup
This chapter describes how to install, configure, and use the NI RMC-8355.
Before connecting the NI RMC-8355 to a power source, read this chapter
and the
Read Me First: Safety and Electromagnetic Compatibility
document included with your NI RMC-8355.
Safety Information
Caution
Before undertaking any troubleshooting, maintenance, or exploratory procedure,
carefully read the following caution notices.
Caution
Product functionality can be disrupted if the knurled thumbscrews on the back of
the top cover are subjected to Electrostatic Discharge (ESD). To prevent damage, you must
employ industry-standard ESD prevention measures during installation, maintenance, and
operation.
Caution
Overloading the circuits may damage supply wiring. Do not exceed the ratings on
the equipment nameplate when connecting equipment to the supply circuit.
Note
Tighten the thumbscrew for the top panel cover with a tool after both initial
installation and subsequent access.
Caution
To avoid risk of explosion, do not replace the battery (JBAT1) with an incorrect
battery type. Dispose of used batteries according to the battery instructions.
This equipment contains voltage hazardous to human life and safety, and is
capable of inflicting personal injury.
•
Chassis Grounding
—The NI RMC-8355 requires a connection from
the premise wire safety ground to the NI RMC-8355 chassis ground.
The earth safety ground
must
be connected during use of this
equipment to minimize shock hazards. Refer to the
section for instructions on connecting safety ground.
•
Mechanical Loading
—To avoid a hazardous load condition, be sure
the mechanical load is even when rack mounting the equipment.
