Note
MAX uses UDP 44525. Refer to the documentation of your
firewall software for information about configuring the firewall to
allow communication through the UDP 44525.
3. Launch MAX on the host computer.
4. Expand
Remote Systems
in the configuration tree and locate your system.
Tip
MAX lists the system under the model number followed by the
serial number, such as NI-cRIO-9065-1856AAA.
Configuring Startup Options
Complete the following steps to configure the cRIO-9065 startup options in MAX.
1. In MAX, expand your system under Remote Systems.
2. Select the
Startup Settings
tab to configure the startup settings.
cRIO-9065 Startup Options
You can configure the following cRIO-9065 startup options.
Table 1.
cRIO-9065 Startup Options
Startup
Option
Description
Force Safe
Mode
Rebooting the cRIO-9065 with this setting on starts the cRIO-9065 without
launching LabVIEW Real-Time or any startup applications. In safe mode, the
cRIO-9065 launches only the services necessary for updating configuration and
installing software.
Enable
Console Out
Rebooting the cRIO-9065 with this setting on redirects the console output to the
RS-232 serial port. You can use a serial-port terminal program to read the IP
address and firmware version of the cRIO-9065. Use a null-modem cable to
connect the RS-232 serial port to a computer. Make sure that the serial-port
terminal program is configured to the following settings:
■
115,200 bits per second
■
Eight data bits
■
No parity
© National Instruments
5
cRIO-9065 Features
