What to Do
Complete the following steps to connect a power supply to the cRIO-9036.
1. Ensure that your power supply is powered off.
2. Install the ferrite on the negative and positive leads of the power supply, as
shown in the following figure.
Figure 1. Installing a Ferrite on the Power Leads
2
1
1. Pass the leads through the ferrite twice, leaving 50 mm to 75 mm (2 in.
to 3 in.) between the ferrite and the end of the leads.
2. Close the ferrite around the leads.
3. Remove the power connector from the cRIO-9036.
Caution
Do not tighten or loosen the terminal screws on the power
connector while the cRIO-9036 is powered on.
4. Connect the primary power supply and optional secondary power supply to
the power connector, as shown in the following figure.
Figure 2. cRIO-9036 Power Connections
Power Connector
V2
C
C
V1
Primary Power Supply
+
–
–
+
Secondary Power Supply
Ferrite
Ferrite
ni.com
12
cRIO-9036 Getting Started
