NI Climbing Frames Triple 6 foot double climbing frame, Assembly Instructions Manual

Page: 3 / 17

pg. 3
Step1: Ground Preparation (see Diagram 1)

Lay out the bases in the position that you envisage them going

Make sure the frames ‘line’ up with each other and are no more than 8ft apart

When placing the bases please ensure you allow for 6 ft clearance beyond the end of the
slide and 3 ft clearance for all other modules.

Once you are happy that the layout is correct, mark out clearly all 8 corners of the bases

If the climbing frame is on a level surface then dig 4 holes of diameter 12” and depth 12”.
The tricky part is when the surface is uneven; in this case you would have to compensate for
the slope by making some holes deeper than others. The easiest way is to take a spirit level
and see how much the ground slopes and dig the rest of the holes accordingly.

The bottom of all 4 holes need to be level
Step2: Base Preparation

Lay 2 of the 10ft posts that are cut at the 40% angle on a level surface

Ensure the cut angle is facing the same way on both posts and that the 32mm holes (about
halfway up) are facing outwards

Now place the 1571mm 4”x4” post between the 2 larger posts

Line up the markings as shown below